Remote Commands
R&S
®
FSW
717User Manual 1173.9411.02 ─ 19
Suffix:
<gap>
.
1 | 2
Gap (CACLR) channel number
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Weighting Filters" on page 171
[SENSe:
]POWer:ACHannel:FILTer:STATe:SBLock<sb>:CHANnel<ch> <State>
This command turns the weighting filter for the specified transmission channel on and
off.
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<State> ON | OFF
*RST: W-CDMA: ON, other technologies: OFF
Manual operation: See "Weighting Filters" on page 167
[SENSe:]POWer:ACHannel:SBCount <Number>
This command defines the number of sub blocks, i.e. groups of transmission channels
in an MSR signal.
For more information see chapter 5.3.3.4, "Measurement on Multi-Standard Radio
(MSR) Signals", on page 145.
Parameters:
<Number> Range: 1 to 5
*RST: 1
Manual operation: See "Number of Sub blocks" on page 162
[SENSe:]POWer:ACHannel:SBLock<sb>:BANDwidth|BWIDth[:CHANnel<ch>]
<Bandwidth>
This command defines the bandwidth of the specified MSR Tx channel.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<Bandwidth> Bandwidth in Hz
Configuring and Performing Measurements
To Next Page
Loading...
