Rohde & Schwarz FSW43 - Page 760

Remote Commands
R&S
®
FSW
760User Manual 1173.9411.02 ─ 19
Parameters:
<Bandwidth> Bandwidth in Hz
*RST: 10.0 MHz
Example:
//Select the band category 1
ESP2:MSR:BCAT BC1
//Set the base station class to medium range
ESP2:MSR:CLAS MED
//Set the maximum output power to 10 dBm.
ESP2:MSR:MPOW 10
//Set the frequency range of the base station to > 3 GHz
ESP2:MSR:BAND:HIGH
//Set the base station RF bandwidth to 20 MHz
ESP2:MSR:RFBW 20MHZ
//Calculate limits for MSR SEM
ESP2:MSR:APPL
Manual operation:
See "Base Station RF Bandwidth" on page 221
11.5.6.8 Configuring the List Evaluation
The following commands configure the list evaluation.
Useful commands for SEM measurements described elsewhere
● MMEMory:STORe:LIST on page 1013
Remote commands exclusive to SEM measurements
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:AUTO...................................................760
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch[:IMMediate]...........................................760
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:MARGin................................................761
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:PSHow................................................. 761
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:AUTO <State>
This command turns the list evaluation on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
CALC:ESP:PSE:AUTO OFF
Deactivates the list evaluation.
Manual operation: See "List Evaluation (Result Summary) State" on page 225
See "List Evaluation State" on page 247
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch[:IMMediate]
This command initiates a list evaluation.
Configuring and Performing Measurements