Remote Commands
R&S
®
FSW
771User Manual 1173.9411.02 ─ 19
The command requires option R&S FSW-B24.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<Gain> 15 dB | 30 dB
The availability of preamplification levels depends on the
R&S FSW model.
• R&S FSW8/13: 15dB and 30 dB
• R&S FSW26 or higher: 30 dB
All other values are rounded to the nearest of these two.
*RST: OFF
[SENSe:
]LIST:RANGe<range>:LIMit:STARt <Level>
This command defines an absolute limit for a spurious emission measurement range.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<Level> Absolute limit at the start frequency of a SEM range.
Range: -400 to 400
*RST: 13
Default unit: dBm
Manual operation: See "Abs Limit Start/Stop" on page 246
[SENSe:]LIST:RANGe:LIMit:STATe
This command turns the limit check for all spurious emission measurement ranges on
and off.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Limit Check" on page 246
[SENSe:]LIST:RANGe<range>:LIMit:STOP <Level>
This command defines an absolute limit for a spurious emission measurement range.
Suffix:
<range>
.
1..30
Selects the measurement range.
Configuring and Performing Measurements
To Next Page
Loading...
