Rohde & Schwarz FSW43 - Page 946

Remote Commands
R&S
®
FSW
946User Manual 1173.9411.02 ─ 19
Manual operation: See "Marker Search Type" on page 503
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MAXimum:ABOVe
This command moves a marker vertically to the next lower peak level for the current
frequency.
The search includes only frames above the current marker position. It does not change
the horizontal position of the marker.
Usage: Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MAXimum:BELow
This command moves a marker vertically to the next lower peak level for the current
frequency.
The search includes only frames below the current marker position. It does not change
the horizontal position of the marker.
Usage:
Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MAXimum:NEXT
This command moves a marker vertically to the next lower peak level for the current
frequency.
The search includes all frames. It does not change the horizontal position of the
marker.
Usage:
Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MAXimum[:PEAK]
This command moves a marker vertically to the highest level for the current frequency.
The search includes all frames. It does not change the horizontal position of the
marker.
If the marker hasn't been active yet, the command looks for the peak level in the whole
spectrogram.
Usage:
Event
Manual operation: See "Marker Search Type" on page 503
Analyzing Measurements (Basics)