Rohde & Schwarz R&S TSME6 - Page 19

Getting started
R&S
®
TSME6
19User Manual 4900.0033.02 ─ 08
Configuring the LAN interface on the host PC
Each R&S TSME6 has the default IP address 192.168.0.2. It is recommended that you
define the fixed IP address 192.168.0.1 to the host PC or configure the host PC to
obtain an IP address automatically ("Auto-IP").
To control the R&S TSME6 from the host PC, the LAN interface of the host PC must be
configured as follows:
1. Press the "Windows" key or the [CTRL + ESC] key combination on your keyboard
to access the Windows "Start" menu.
2. Type "Control Panel" and select this application.
3. Select "Control Panel > Network and Internet > Network and Sharing Center".
4. Select "Change adapter settings".
5. Double-click the LAN interface with which the R&S TSME6 is connected.
The items used by the LAN connection are displayed.
6. Select the entry named "Internet Protocol Version 4 (TCP/IPv4)".
7. Select the "Properties" button.
8. Configure the following TCP/IP settings:
a) Use any "Auto-IP" mode.
Select "Obtain an IP address automatically".
Preparing for use