Preparing for use
R&S
®
Scope Rider RTH
23Getting Started 1326.1561.02 ─ 10
2. Fold out the tilt stand on the back of the instrument.
3. Screw open the battery cover.
4. CAUTION! Use only the specified Li-ion battery pack, which is delivered with
the instrument. You can order additional battery packs at Rohde & Schwarz,
see the specifications document for order number.
Insert the battery pack.
5. WARNING! Do not operate the instrument with the battery cover open.
Screw down the battery cover.
6. CAUTION! Use only the specified power adapter, which is delivered with the
instrument.
Connect the power adapter to the connector on the left side of the oscillo-
scope.
7. Fully charge the battery. Charging can take a few hours.
If the instrument is on, the battery status is shown on the display. Now you can
use the instrument.
Handling the battery
To Next Page
Loading...
