Rohde & Schwarz Scope Rider RTH1004 - 5.3.2 Using the navigation wheel

Operating the instrument
R&S
®
Scope Rider RTH
38Getting Started 1326.1561.02 ─ 10
5.3.2 Using the navigation wheel
In addition or alternatively to the touchscreen, you can use the wheel to control
the R&S RTH.
When using the wheel, always observe the position of the focus - the orange
frame or other highlighting that marks the active object on the screen.
●
If the focus is on the menu button or somewhere in the menu or dialogs:
– Turn the wheel to move the focus.
– Press the wheel button to apply the selection.
●
If the focus is on an element in the diagram, for example, on a waveform, cur-
sor line, or trigger level:
– Turn the wheel to change the position of the active element.
– Press the wheel button to toggle the active element, for example, to toggle
the cursor lines, or zoom size and zoom position.
The [BACK] key closes open dialogs and menus, and resets the focus to the
"Menu" button.
Menu navigation
The following procedure describes how to access and navigate the menu. Navi-
gating dialogs and selecting parameter values works in the same way. See also
Figure 5-5.
1. Press [BACK] until the focus is on the "Menu" button.
2. Press the wheel button to open the menu.
3. Turn the wheel to move the focus to the required menu item.
4. Press the wheel button to open the dialog, submenu, or keypad for the
selected menu item.
Accessing the functionality