Operating the instrument
R&S
®
Scope Rider RTH
44Getting Started 1326.1561.02 ─ 10
Key Press shortly Press and hold
[SIGNAL OFF] switches off the focused
waveform.
[RUN STOP] starts and stops the acquisition.
[SETUP] opens or closes the "Trigger" dialog to select the trigger type and
adjust the trigger settings.
[LEVEL] activates the trigger level to be set using the wheel. If the trigger
type has two trigger levels, pressing the key toggles the upper and lower
levels.
[ACQUIRE] opens or closes the "Acquire" dialog to adjust the acquisition
mode.
[Power] key: switches the power on or off
5.4 Displaying an unknown signal
The R&S RTH can display unknown, complex signals automatically. The
[AUTOSET] function analyzes the enabled channel signals, and adjusts the hori-
zontal, vertical, and trigger settings to display stable waveforms.
1. Press the [PRESET] key.
[PRESET] sets the instrument to a default factory state. The previous user-
defined configuration is removed and all channels except for channel 1 are
disabled.
2. Press the [AUTOSET] key.
The waveform is displayed.
Displaying an unknown signal
To Next Page
Loading...
