Rohde & Schwarz Scope Rider RTH1004 - 3.3 Powering on;off; 3.4 Using the tilt stand

Preparing for use
R&S
®
Scope Rider RTH
24Getting Started 1326.1561.02 ─ 10
3.3 Powering on/off
► Press the [Power] key to switch the instrument on or off.
The key blinks and turns green after a few seconds.
Table 3-1: Colors of the [Power] key
Green Power is on
Blue Charging the battery, power is off
Orange (yellow) Battery is fully charged, power adapter is connected, power is off
If you do not use the instrument for a longer time, the battery gets exhausted.
When you connect the power supply and switch on the instrument with an
exhausted battery, it takes a few minutes until the instrument can start.
3.4 Using the tilt stand
The R&S RTH has a tilt stand for proper handling while the scope is placed on a
table.
► Pull the tilt stand as shown below.
Using the tilt stand