Instrument tour
R&S
®
Scope Rider RTH
30Getting Started 1326.1561.02 ─ 10
4.3 Right view
1 = LAN
2 = USB type B for remote control
3 = Probe compensation
4 = USB type A for flash drive
5 = Logic probe connector
Risk of injury or instrument damage
Always close the lids of the communication ports and DC input when they
are not in use.
LAN connector
RJ-45 connector to connect the instrument to a Local Area Network (LAN). It sup-
ports up to 100 Mbit/s.
USB type A connector
USB type A (host USB) connector to connect a USB flash drive to store and
reload instrument settings and measurement data. This USB interface is isolated
and has only limited functionality, it can only be used for transfer of oscilloscope
data files and firmware update. Installing any other software is not possible.
USB type B connector (mini USB)
Mini USB connector (device USB) to connect a computer for remote control of the
instrument. The connector is only active if USB is selected in the interface set-
tings.
Right view
To Next Page
Loading...
