Roland DR-880 - Copying a TSC Patch

104
Saving/Copying a TSC patch
Copying a TSC patch
1. In the TSC patch edit screen, move the
cursor to “COPY” and press [ENTER].
The TSC patch copy screen appears.
fig.05-050d
2. Move the cursor to the copy-source patch
number, and use the VALUE dial to select
the patch number you want to copy from.
3. Move the cursor to the copy-destination
patch number, and use the VALUE dial to
select the patch number you want to copy
to.
4. To execute the copy, press [ENTER].
If you decide to cancel, press [EXIT].
The message “Now writing...” will appear,
and the copy will be carried out.
When the copy is completed, the message
will disappear.
* Do not turn off the power while the message is displayed.
Your data may be damaged if you do so.
Copy
source
Copy
destination