90
Using the Tuner/Expression pedal
Tuning your guitar/bass
The DR-880 contains a chromatic tuner that you
can use to tune your guitar/bass connected to
the GUITAR/BASS INPUT jack.
1. Press [TUNER].
The tuner screen appears.
fig.04-030d
2. Play a single note on the string you want
to tune.
The display shows the name of the note
closest to the pitch of the string you played.
* Cleanly play a single note on just the string you are
tuning.
3. Tune your instrument so that the correct
note is shown for the string you’re tuning.
(Typical tuning for each string)
4. Watch the tuning guide, and tune your
instrument so that both left and right
indicators are lit.
fig.04-040d
5. Repeat steps 2–4 to tune the remaining
strings.
* If you’re tuning a guitar that has a vibrato arm, tuning
one string may cause other strings to drift. First tune the
strings approximately so that the correct note names are
displayed. Then continue tuning each string until they
are all correct.
6. When you have tuned all of strings, press
[EXIT].
7th 6th 5th 4th 3rd 2nd 1st
Guitar B E A D G B E
Bass B E A D G
Tuning guide
When the pitch
is higher than
the Displayed
note
When the pitch
matches the
Displayed note
When the pitch
is lower than
the Displayed
note
To Next Page
Loading...
