72
Using Groove Modify
7. To execute with the specified settings,
press [ENTER]. To cancel, press [EXIT].
8. If you want to save the pattern, proceed
to “Saving a pattern” (p. 65).
Adding ghost notes
By adding “ghost notes” to the pattern you can
create a realistic sense of groove, just as in an
actual drum performance.
1. Select a pattern (p. 50).
2. Press [GROOVE].
The groove modify menu screen appears.
fig.02-110d
3. Move the cursor to the “GHOST NOTE”
icon and press [ENTER].
The ghost note setting screen appears.
fig.02-140d
4. Move the cursor to the relevant item, then
use the VALUE dial to set the value.
5. To execute with the specified settings,
press [ENTER]. To cancel, press [EXIT].
6. If you want to save the pattern, proceed
to “Saving a pattern” (p. 65).
0–150% Adjust the volume of the bass
A setting of 0% will make the sound extremely faint.
With a setting of 100%, the velocity will be as specified
in the pattern.
Settings of 101% or higher will make the velocity higher
than specified in the pattern.
Parameter/
Range
Explanation
Parameter/
Range
Explanation
On/Off
OFF, ON Turn Ghost Note on/off
* You can also press [GROOVE] to turn this on/off.
Template
see below
Number of the template that you
want to use
STRAIGHT 1–20:
These are appropriate for straight patterns.
SHUFFLE 1–20:
These are appropriate for shuffle patterns.
Depth
0–100 Volume of the ghost notes
To Next Page
Loading...
