121
System settings
Chap. 8
Using foot switches
You can connect up to foot switches (such as the
FS-6, FS-5U: sold separately) to the rear panel
CTL 1, 2 jack and CTL 3, 4/EXP PEDAL jack,
and use them to control the function you assign,
such as playback start/stop.
When Connecting the FS-6
fig.07-081
• Use a stereo 1/4” phone plug ←→ stereo 1/
4” phone plug cable to make connections.
• Set the MODE switch and POLARITY switch
as shown in the figure.
fig.07-082
When Connecting the FS-5U
fig.07-080
• In order to connect two foot switches to a
jack, you will need a special cable (PCS-31;
sold separately).
• Set the POLARITY switch as shown in the
figure.
fig.07-083
When connecting a single FS-5U to each
jack
fig.07-084
• If you connect only one foot switch to each
jack, the settings for Sw. 1 and Sw. 3 will be
used.
Sw. 4 Sw. 3 Sw. 2 Sw. 1
stereo 1/4” phone plug
stereo 1/4” phone plug
PCS-31 PCS-31
Sw. 4 Sw. 3 Sw. 2 Sw. 1
red white red white
Sw. 1Sw. 3
To Next Page
Loading...
