25
Playing the patterns
Quick Start
* If you turn the VALUE dial while holding down [SHIFT], the
pattern number will change in steps of ten.
* You can hold down [SHIFT] and press [SONG/PATTERN] to
switch between preset (P) and user (U).
3
Press [ ].
The selected pattern will begin playing.
During playback, you can turn the VALUE dial to reserve
the pattern to be played next.
The name of the reserved pattern is highlighted.
When the current pattern finishes playing, the reserved
pattern will start playing.
* If you press [CURSOR] / during playback, you will
switch to the previous/next pattern, and it will start playing
immediately.
This is convenient when you want to listen to the patterns while
you’re selecting among them.
4
To stop playback, press [ ].
If you press [ ] once again, playback will resume from
where it was stopped.
If you press [ ] and then press [ ], playback will
start from the beginning of the pattern.
The DR-880’s patterns
contain a “drum part” and a
“bass part.” The drum part
plays drum and percussion
sounds, and the bass part
plays bass sounds.
For more on the Preset Patterns, refer to p. 156.
To Next Page
Loading...
