EasyManua.ls Logo

Roland DR-880 - Page 94

Roland DR-880
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
94
Guitar effects parameter list
COMPRESSOR: GTR MULTI
This effect produces long sustain by making the
volume of the input signal more uniform. You can
also use this as a “limiter” to prevent distortion by
holding down just the peaks of the sound.
A-WAH (Auto wah)
This effect automatically creates a wah effect by
sweeping a filter in a fixed pattern.
P-WAH (Pedal wah)
This effect produces the sound of a wah pedal.
* If an expression pedal (Roland EV-5; sold separately) is
connected to the rear panel CTL3, 4/EXP PEDAL jack,
the expression pedal will function as a wah pedal.
CHORUS
This effect creates a beautifully rich and spacious
sound by adding a slightly pitch-modulated
sound to the sound of the guitar or bass.
Parameter/
Range
Explanation
Sustain
0–100
Adjusts the duration of time over
which low-level input signals will
be boosted to a steady volume
Higher settings of this parameter will produce longer
sustain.
Level
0–100 Volume of the effect sound
Parameter/
Range
Explanation
Polarity
UP, DOWN
Specifies the direction that the filter
moves in response to the input
UP:
The filter will move toward a higher frequency.
DOWN:
The filter will move toward a lower frequency.
Sens
0–100
Specifies the sensitivity of the filter
movement
Freq
0–100 Center frequency of the wah effect
Peak
0–100
Depth of the wah effect in the re-
gion of the center frequency
Higher values produce a stronger tone which empha-
sizes the wah effect more. A setting of “50” produces
the typical wah sound.
Rate
0–100,
BPM –BPM
Auto wah rate (speed)
* If you set this to BPM, the effect will synchronize to the
tempo of the pattern. If this produces a cycle that is too
fast, the effect will synchronize to 1/2 or 1/4 of the actual
BPM.
Depth
0–100 Depth of the wah effect
Level
0–100 Volume of the effect sound
Parameter/
Range
Explanation
Level
0–100 Volume of the effect sound
Parameter/
Range
Explanation
Rate
0–100,
BPM –BPM
Effect modulation rate
* If you set this to BPM, the effect will synchronize to the
tempo of the pattern. If this produces a cycle that is too
fast, the effect will synchronize to 1/2 or 1/4 of the actual
BPM.
Depth
0–100 Depth of the effect
E.Level
0–100 Volume of the chorus sound
Parameter/
Range
Explanation

Table of Contents

Related product manuals