Roland Fantom-X6 - Playing in Patch Mode; About the Patch Play Screen; Selecting a Patch

38
Adjusting the volume balance
When using a layer or split in Performance mode, you can adjust the volume
and pan of each patch.
1. Enter Performance mode (the MIXER screen).
2. Confirm that the indicators at the right of the knobs are extinguished. (If an indicator is lit, press the
button below the indicators a number of times until it goes out.)
If these indicators are unlit, the knobs are controlling the parameters shown in the display.
fig.1-09b
3. Select the group of parts that you want to control.
Use the cursor buttons (up/down) to select the level slider. You can use [F7 (Part ← )] or [F8 (Part → )] to
move the green frame (which indicates the four parts being controlled by knobs).
fig.1-09c
* To adjust the volume balance between the keyboard and pads in Patch mode, access the Patch screen and press
[F3 (Part Level)] to access the “Part Level” screen.
When you save a performance, the settings you adjusted in the MIXER screen are also
saved.
→ “Saving a Performance You’ve Created (Write)” (p. 120) in Owner’s Manual
Procedure
Fantom-X_HB_e.book 38 ページ ２００５年５月２４日 火曜日 午前１１時１２分