44
Using effects
The Fantom-X provides five effects processors; multi-effect (MFX), chorus,
reverb, mastering and input effect.
In the Patch mode screen, press the [EFFECTS] button to view a diagram that shows how the effects
processors are connected. This shows at a glance the effect types and routing for the patch you are now
playing.
fig.2-10
In the Performance mode screen, press the [EFFECTS] button to view a diagram that shows how the effect
processors are connected. Here you can use up to three multi-effects processors, and even connect them in
series. Performance mode is also a good choice if you want to use several effects to create your sound.
fig.2-11
You’ll need to make special settings if you want the patches to use the same effect settings
as in Patch mode.
→
“MFX1–3 Source (Multi-Effects 1 Source)”
(p. 212) in Owner’s Manual
Using effects with a patch
Using effects with a performance
All instrumental sounds are being sent to MFX-1.
MFX-1->OUTPUT A
Send level
MFX-1->Chorus
Send level
MFX-1->Reverb
Send level
The signal sent from
OUTPUT A combines:
• The direct sound from MFX-1
• The sound sent from Chorus
• The sound sent from Reverb
Routing screen
Fantom-X_HB_e.book 44 ページ ２００５年５月２４日 火曜日 午前１１時１２分
To Next Page
Loading...
