Roland FR-3x - Page 63

3. Set the MIDI receive channelon the external
device to "13".
See its manual for details. If yo u are u nab le to
change th e receiver's MI DI channel, set the FR -3x's
control channel to match the external instrul11ent's
"R X" channel. See "Control Channel T X" on p. 60.
4. Press and hold the [ORGAN/ORCHESTRA]
register and press register [5] (SEND PC).
5. Use treble registers [1 ]~[O] to enter the
"SPC" numb er.
Yo u l11 ay hav e to look in the owner's manua l of th e
module or sv nth es i ze r VOU a re controlling to fi nd
out wh ich number VOU n ee d to transmit for the
sound (or
memorv) vou wa nt to se l ec t. You can
enter anv number from "1 " to "512".
See the fo ll owing table fo r ho w to enter numbers.
SPC Ilumber
CCOO/CC32 va lu es Trall smitted PC
to trallsrnit
llul11b e rs
1~ 1 28 Mell10ry 1
1 ~ 1 28
129 ~2 56
Mell10ry 2
1 ~ 1 28
257~384
Mell10ry 3
1 ~ 1 28
385 ~5 1 2 Mell10ry 4
1~128
If VOU enter a number bet ween "129" a nd "256",
the FR -3x transmits the CCOO a nd CC32 va lu e pro-
gr am m ed for memo rv 2. Th e program cha ng e
number,
on the other h an d will alwavs be a num-
ber between "1" an d "128".
E
xa mpl e: if vou enter "1 30" for the "SPC" par ame -
ter, th e
FR -3x enters program change numb er "2"
( see the table above).
[NOTE]
The [o] register ac ts as "O" here. To en ter "502" , for exall1p l e,
press registers [sl. [ol. and [2].
6. If necessa ry, pr ess the [SEl] reg ister to erase
the
last entry you made.
If vo u entered "55", for example, while t he second
fig u re should have been a "2", press [SE T] ollce (50
that the display inclicates "--5" againl, then press
regis te r [2] ("-52")
V -Acco rdi o l1 Roland
Transmitt ing a program change message to an external device
Note: T he FR-3 x us es a smart entry system: after entering "52"
(or "53" , "54", "55", ... "59"), you can't add a third figure,
because the highest number supported by th e SEND PC func-
tion
is "5 1 2".
7. Press the [ORGAN/ORCHESTRA] register to
transmit the
CCOO, CC32 and PC messages.
63