Roland FR-4X - Selecting Right-Hand Sounds

7
Panel Descriptions
1
[
L
] (power) button
Turns the power on/off (p. 15).
MEMO
If you need to turn off the power completely (when using the
supplied AC adaptor), first turn off the [
L
] button, then disconnect
the AC adaptor’s plug from the wall outlet.
5 With the factory settings FR-4x’s power will automatically be
switched off 240 minutes after you stop playing or operating
the FR-4x.
If FR-4x’s power has been turned off automatically, you can
use the [
L
] button to turn the FR-4x back on.
If you don’t want the power to turn off automatically, set the
“Auto Off”parameter to “OFF” (p. 74).
NOTE
Be aware that any unsaved changes are lost when the FR-4x is
switched off by that function.
2
[VOLUME] knob
Adjust the FR-4x’s overall volume.
3
[BALANCE] knob
This knob allows you to set the balance between the right hand
and the left hand sections.
4
[EXIT/NO] button
The [EXIT/NO] button allows you to return to the main page.
In the menu screen, press this once to return to the screen of the
next-higher level.
If you hold down this button in the menu screen, you’ll return
directly to the main screen.
In screens that ask for confirmation, press this to respond NO.
5
[ENTER/YES] button
In the menu screen, where only the parameter name and not the
value is shown, press this to enter a lower level.
In screens that ask for confirmation, press this to respond YES.
6
[MENU (WRITE) ] button
Access the MENU screen.
This button allows you to select the FR-4x’s MENU environment
where you can set and view all available functions (p. 44).
By holding down [MENU/WRITE], you activate the WRITE function,
which allows you to save your User Program, Set and Settings.
7
[
K
] [
J
] buttons
In the main screen, use this to switch the sound selection screen of
each part.
In the menu screen, use this to select parameters.
8
[–] [+] buttons
In the MENU screen, these change the value.
Hold down a button to change the value continuously.
To rapidly raise the value, hold down the [+] button and press the
[–] button.
To rapidly reduce the value, hold down the [–] button and press the
[+] button.
By holding down [SHIFT] and pressing [–] [+] you can change the
value in increments of 10 times the usual increment.
In the main screen, these change the SET.
9
LEFT HAND section
These buttons allow to switch On/Off the parts controlled in the
left hand:
DRUM, ORCH BASS, ORCH CHRD/F.BASS, FBASS, BASS & CHORD
10
RIGHT HAND section
These buttons allow to switch On/Off the parts controlled in the
right hand:
ACCORDION, ORCHESTRA, ORGAN
11
[SHIFT] button
By using this in conjunction with other buttons you can access
alternate functions for those buttons.
&
“List of Shortcut Keys” (p. 105)
12
Right hand registers
The 7 right hand registers allow you to select the desired sound.
NOTE
If you hold down a right hand register button, the selected
part is muted, so that playing the keyboard does not produce
sound (keyboard data is transmitted only via MIDI).
When you once again press the right hand register button,
muting is cancelled.
Right Hand Control Panel
18
16 17
9 2
4
6
7
8
1
3
5
11 12 13
14 15
10