143
Appendices
Sound won’t stop sounding
● With some sequencing programs, sound may continue to sound if you change
the recording tracks while playing the keyboard.
In that case, press the [MUTE] button of the SC-8850 to stop the sound, then press
the [MUTE] button again to restore the previous state. (p.35)
Sound is wrong
● Have you selected another sound after modifying sound parameter settings
(filter, etc.)?
Restore all sound parameter settings to a value of 0. (p.64, p.68)
● On occasion, you may find that the SC-8850’s parameter settings have gone
awry.
To remedy such situations, initialize the unit for either General MIDI or GS. (p.24)
Sounds are interrupted
● If you play more than 128 voices at once, sounds will be interrupted. (p.48)
● Is the same data being sent simultaneously to MIDI IN 1 and MIDI IN 2?
Can’t playback more than 32 parts
● The SC-8850 can play more than 32 parts only when connected via the USB
connector or the serial connector.
When the SC-8850 is connected via the MIDI connectors, it can play a maximum of
32 parts.
Exclusive messages are not received
● Does the Device ID number of the transmitted Exclusive message match the
Device ID number of the SC-8850? (p.50)
The SC-8850 does not transmit MIDI data
● If you wish to transmit this unit data via the USB connector or the Serial con-
nector, set the Computer switch to USB, PC, or Mac, depending on your com-
puter. (p.12, p.14)
● When the Computer switch of the SC-8850 is set to MIDI, the SC-8850 will not
transmit data from the USB connector or the Serial connector.
MIDI sound generators connected to the SC-8850 are not played
from a computer or sequencer
● Music data received at the SC-8850 USB connector or the Serial connector is
transmitted from the MIDI OUT connector.
Make the correct settings on your sequencer software and driver.
When using an insertion effect, the panpot of a part has no
effect — the sound is located in the center
● Depending on the algorithm, this may have no effect.
The insertion effects are designed to be inserted after the part pan. Use the pan of the
insertion effects.
Even if the SC-8850 is
initialized for General
MIDI/GS, the System
parameter settings will not
e affected.
To Next Page
Loading...
Need help?
General
