43
Parts and Sounds
■ Selecting Drum Sets (Drum Part)
In the case of the Drum Part, sounds are selected in a different way than for a normal
Part.
In a Drum Set, different sounds are assigned to each note of the keyboard. When you
select a Drum Part and play the keyboard, a different sound will sound for each note.
This is because it is not necessary to specify the pitch of a drum sound.
Drum Sets can be selected in the same way that you select capital sounds for a nor-
mal Part.This means that Variation numbers are not used for the Drum Part.
1
Make sure that the Part Basic screen is selected.
2
Press PART [ ] or [ ] to select a Drum Part.
At the factory settings, the Drum Parts are set to Part 10 (A10, B10, C10, D10).
3
Press INST [ ] to move the cursor to INST.
fig.4-9
4
Rotate the [VALUE] knob, or press [DEC] or [INC] to select the Drum Set.
Pressing [DEC] decreases the Drum Set Number and pressing [INC] increases the
Drum Set Number.
For the types of Drum Sets, refer to Drum Set List (p.187).
Part Basic screen (p.29)
To Next Page
Loading...
