EasyManuals Logo

Roland Sound Canvas SC-8850 User Manual

Roland Sound Canvas SC-8850
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
65
Creating a Sound or Drum Set
Parameters for Sound Editing
On the SC-8850, parameter settings are made for each Part. In other words, parame-
ter values belong to Parts, and not to sounds (Instruments). For example, if you set
Vibrato Rate to +20 and then select a different sound for that Part, the Vibrato Rate
of +20 will apply to the newly selected sound (not the initial value of +/-0). In this
way, parameters belonging to Parts are called Part parameters.
Vibrato
Vibrato is an effect created by modulating the pitch. Applying vibrato makes the
sound more expressive.
Vib Rate (Vibrato Rate) -640+63
This parameter adjusts the speed (frequency) of the pitch modulation. Positive (+)
settings make the pitch modulation faster, and negative (-) settings make it slower.
Vib Depth (Vibrato Depth) -640+63
This parameter adjusts the depth of the pitch modulation. Positive (+) settings make
the pitch modulation deeper, and negative (-) settings make it shallower.
Vib Delay (Vibrato Delay) -640+63
This parameter adjusts the time required for the vibrato effect to begin. Positive (+)
settings increase the time before vibrato will begin, and negative (-) settings shorten
the time.
fig.6-2e
Filter
By modifying the filter settings, you can control the timbre (tone) of the sound. The
type of filters in the SC-8850 are called Low Pass Filters, and allow only frequencies
lower than a specified frequency to pass. This frequency is called the Cutoff Frequen-
cy. By modifying the setting of the Cutoff Frequency you can make the sound bright-
er or darker. The Cutoff Frequency can change over time, controlled by the envelope.
By adjusting the filter and envelope settings, you can create sounds that have move-
ment and expression.
fig.6-3e
Parameters such as Vibrato,
Filter and Envelope can be
set not only for Parts, but
also for sounds (Instru-
ments). Sounds you create
b
y modifying these param-
eters are called User
Instrument, and can be
stored in the SC-8850 map
memory area (p.67).
Delay
Depth
Note On
Rate
Higher frequencies
Lower frequencies
Cutoff frequency
Low
pass
filter

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roland Sound Canvas SC-8850 and is the answer not in the manual?

Roland Sound Canvas SC-8850 Specifications

General IconGeneral
BrandRoland
ModelSound Canvas SC-8850
CategorySynthesizer
LanguageEnglish

Related product manuals