Roland TrueVIS VG-640 - Correcting the Misalignment of the Printing and Cutting Positions During Cutting

Advanced Cutting Settings
4
Advanced Functions
144
Correcting the Misalignment of the Printing and Cutting Positions during Cutting
Procedure
A
During cutting, press [PAUSE] to display the screen shown below.
TO CANCEL HOLD
DOWN PAUSE KEY
The cutting operation is paused.
B
Press [FUNCTION].
C
Press [ ] several times to display the screen shown below.
FUNCTION
CUT CONFIG
D
Press [ ] once, and then press [ ] several times to display the screen shown below.
CUT CONFIG
PRINT-CUT ADJ.
E
Press [ ].
F
Determine the correction values.
Printing position and cutting
position are misaligned.
Correct the
misalignment.
[F] (media feed direction)
[S] (cutting carriage movement direction)
[F]
[S]
+
+
-
-
Cutting position
Printing position