Roland TrueVIS VG-640 - Drying Time

Basic Printing Method
2
Basic Operation
50
J
Press [ENTER] to conrm your entry.
If you select "YES," the test pattern (C&C1) is printed and cut again. Go back to step
G
and perform
the setting again.
If you select "DONE," proceed to the next procedure.
10. Set the drying method and time after printing. (Separate setting " P.120)
A
Press [ ] or [ ] to select "ENABLE" or "DISABLE."
FEED FOR DRY
DISABLE ENABLE
Current
setting
Setting after
change
MEMO: Drying Method after Printing
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer
after the 1st page is printed. To make sure to dry the entire printed area, select "ENABLE." If "DISABLE"
is selected, the trailing edge of the printing area is not fed to the dryer unless you continue with a
subsequent printing operation.
B
Press [ENTER] to conrm your entry.
C
Press [ ] or [ ] to set the drying time.
DRYING TIME
10min 10min
Current
setting
Setting after
change
MEMO: Drying Time after Printing
Set the drying time after the 1st page is printed. The next operation is not started until the set time
passes.
MEMO: Example of Setting Time (General Guide)
The setting time varies according to the settings such as the type of media and the printing quality.
Condition: Non-coated vinyl chloride media
Setting time: About three minutes
D
Press [ENTER] to conrm your entry.