Roland TrueVIS VG2-540 - Manual Cleaning Method

23
1.Introduction
2. Checking Included Items
The following items are included with the machine. Make sure they are all present and accounted
for.
Power cord (1)
Arms
(1 each for right and le)
Casters (2)
Stand legs
(1 each for right and le)
Stand stay (1) Shas (2) Media stays (2)
Media holders/retaining
screws (1 each for right
and le)
Sha clamps (2) Media holder adjuster (1)
Hexagonal
wrench
(1)
Pipe (1)
Replace-
ment wiper
(1)
Tray pad (1)
Adjustment
bolt (1)
Soware
RIP (1)
Drain bole
(1)
Drain funnel
(1)
Drain bole
stand
(1)
Adjustment pa-
pers (2)
Paper tube (1)
Replacement blade for
separang knife (1)
Blade holder
(1)
Blade (1) Pin (1)
Bolts (long)
(8)
Bolts (short)
(42)
Washer
(8)
Tube joint (1) Tubes (4)
Cable
clamps (2)
Tweezers (1)
Cleaning
liquid (1)
Cleaning
scks
Cartridge-slot labels
(for four colors; 2)*
1
Setup Guide (this document; 1)
Read this rst (1)
Regular Maintenance Guide (1)
For DU2-64/54 *
3
DU2-64 Arm
C (2)
DU2-64 stay (1 each for
right and le)
*1
With the factory default sengs, these labels are axed to the platen at the locaon where the
front cover opens.
*2
Among these 42 bolts, 4 of them are for the oponal DU2-64/54. For details, refer to the DU2-64/54
user's manual.
*3 These are for the oponal DU2-64/54. For details, refer to the DU2-64/54 user's manual.