Roland TrueVIS VG2-540 - Step.7:.Connecting.the.cables; Step 7: Connecting the Cables

44
2.Installation
1. Assembly and Ink Filling
Step 7: Connecting the Cables
Procedure
A
Insert the cable clamp.
B
Connect both the power cord and the Ethernet cable (commercially available).
Use a power plug adapter if the electrical outlet is a two-prong outlet.
WARNING
Perform this task with all power switches le switched o.
Failure to observe this instrucon may cause the machine to move suddenly,
resulng in injury.
WARNING
Connect to an electrical outlet that complies with this machine's rangs (for
voltage, frequency, and current).
Incorrect voltage or insucient current may cause re or electrical shock.
WARNING
Connect the machine to ground.
This can prevent re or electrical shock due to current leakage in the event
of malfuncon.
Ethernet cable
(Category 5 or higher)
Ethernet
(1000BASE-T recommended)
Power cord
Cable clamp
Pass the Ethernet
cable and the pow-
er cord through
here.