Roland TrueVIS VG2-540 - Step.2:.Installing.the.cutting.tool; Step 2: Installing the Cutting Tool

53
2. Installing the Cutting Tool
2.Installation
Step 2: Installing the Cutting Tool
1.
Enter the "REPLACE BLADE" menu.
A
Press [MENU].
B
Press [ ] several mes to display the screen shown below.
MENU
SUB MENU
C
Press [ ] once, and then press [ ] several mes to display the screen shown below.
SUB MENU
MAINTENANCE
D
Press [ ] once, and then press [ ] several mes to display the screen shown below.
MAINTENANCE
REPLACE KNIFE
E
Press [ENTER].
The cung carriage moves to a posion where blade replacement is possible.
F
When the following screen is displayed, open the front cover.
OPEN FRONT
COVER
Preparaons are complete when this screen appears.
FINISHED?
2.
Install the cung tool.
A
Loosen the cung carriage screw.