Roland TrueVIS VG2-540 - Step.2:.Assembling.the.printer.unit.and.the.stand; Step 2: Assembling the Printer Unit and the Stand

30
2.Installation
1. Assembly and Ink Filling
Step 2: Assembling the Printer Unit and the Stand
Important
If you will not use the liing bars, proceed to
P. 32 "2. Fix the printer unit to the stand."
. However, in that
situaon, be sure to perform the work with eight or more people.
1.
Aach the liing bars to the printer unit.
MEMO
• The liing bars and the liing bar xing bolts are not included with the printer. The worker per-
forming the installaon will bring them to the work area.
• Aach the liing bars with the printer unit in the packing box.
State aer aaching the liing bars
A
Temporarily ghten the liing bar xing bolts (4 locaons in total) on the boom sur-
face of the printer unit.
There are 4 screw holes on each side of the boom surface. Use the 2 inner holes on each
side. Tighten the liing bar xing bolts unl you can see approximately 10 mm (0.4 in.) of their
threads.
Tighten
temporarily
Liing bar xing
bolts: 4
About 10 mm
(0.4 in.)