Roland TrueVIS VG2-540 - Page 34

32
2.Installation
1. Assembly and Ink Filling
2.
Fix the printer unit to the stand.
A
With six or more workers, rmly hold the liing bars and li up the printer unit.
CAUTION
Be sure to perform this work with six or more people. Have at least one
person hold each of the four ends of the liing bars and at least one person
hold each end of the housing.
Tasks that require undue eort when performed by a small number of per-
sons may result in physical injury. Dropping this machine may result in injury.
CAUTION
Before liing up the printer unit, check that the liing bars do not rale.
If the liing bars rale, reghten the liing bar xing bolts xing them in
place.
Caution
When not using the lifting bars, be sure to perform the work with eight or
more people.
Tasks that require undue effort when performed by a small number of
persons may result in physical injury. Dropping this machine may result in
injury.
B
Place the printer unit on the stand, and then temporarily ghten the bolts in the order
of
1
,
2
.
Set the assembled stand upright, and then x the printer unit to it by ghtening the (long) bolts (8
locaons in total). Use a washer for each (long) bolt.
Tighten
temporarily
Bolts (long): 8
Washers: 8