Roland TrueVIS VG2-540 - Step.1:.Assembling.the.stand; Step 1: Assembling the Stand

27
2.Installation
1. Assembly and Ink Filling
Step 1: Assembling the Stand
Procedure
A
Place the caster on the stand leg.
Place the stand leg with the tabletop plate facing down, and then place the caster on top of the
stand leg. The casters have no parcular front and rear orientaon.
Tabletop plate
B
Lightly ghten the bolts in the 4 upper locaons and then in the 4 locaons on the
sides.
For the 4 upper locaons, rst ghten the bolts in the narrow slots. In this way you can aach
the caster in the correct posion.
Tighten
temporarily
Bolts (short): 8
NarrowWide
Tighten the bolt
here rst.