Roland TrueVIS VG2-540 - Page 30

28
2.Installation
1. Assembly and Ink Filling
C
Fully ghten the bolts in the 4 upper locaons and then in the 4 locaons on the
sides.
Use the pipe when ghtening the bolts in the upper locaons. When ghtening the bolts fully,
ghten them securely. Loose bolts may cause the stand to wobble.
Tighten fully
Bolts (short): 8
Pipe
D
Assemble the opposing stand leg by following the same procedure from step
A
to
step
C
.
E
Posion the stand legs parallel to each other and separated by approximately 1,800
mm (70.9 in.) for the 64-inch model or approximately 1,500 mm (59.1 in.) for the 54-
inch model.
Posion the legs so that the L-shaped brackets face the inside and the bent side of the tabletop
plate faces down for each leg.
About 1,800 mm (70.9 in.)
(64-inch model)
About 1,500 mm (59.1 in.)
(54-inch model)
Set this part on the boom.
F
Place the stand stay on the stand legs.
Place the stand stay so that its inside touches the L-shaped brackets and the stand legs in order
to make the 2 stand legs parallel.
Posion the surface with aach-
ment holes toward the casters.