Roland TrueVIS VG2-540 - Step.3:.Installing.the.media.holders.and.media.stays; Step 3: Installing the Media Holders and Media Stays

34
2.Installation
1. Assembly and Ink Filling
Step 3: Installing the Media Holders and Media Stays
IMPORTANT: Be sure to follow the procedure.
Aer nishing
P. 27 "Step 1: Assembling the Stand"
and
P. 30 "Step 2: Assembling the Printer Unit and the Stand"
,
perform
P. 34 "Step 3: Installing the Media Holders and Media Stays"
. If this procedure is not followed,
prinng results will be aected because the media holders will not be installed in the correct
posions.
1.
Aach the arms.
A
Temporarily ghten the bolts (short) on the le side of the stand as seen from the
rear of the printer.
Tighten the bolts (short) in the holes on the side of the stand unl you can see approximately 5
mm (0.2 in.) of their threads on each side.
Tighten
temporarily
Bolts (short): 2
Approx. 5
mm (0.2 in.)
Rear
B
Aach the le arm to the temporarily ghtened bolts (short).
Point
Each arm can only be used on either the le or right side. Aach them on the correct sides.
Arm (right)Arm (le)