Roland TrueVIS VG2-540 - Page 37

35
2.Installation
1. Assembly and Ink Filling
C
Lightly ghten the bolts connecng the rear of the stand to the arm's contact surface.
While pressing the side of the arm onto the stand leg, ghten the bolts.
Tighten
temporarily
Bolts (short): 2
D
Fully ghten the bolts in the order of
1
(stand rear),
2
(stand side).
Tighten fully
Bolts (short): 4
E
Aach the other arm to the right side as seen from the rear of the machine.
F
Aach the media holder adjuster to the right arm as seen from the rear of the ma-
chine.
Pass the protrusions of the media holder adjuster
2
through the notches on the arm
1
, and
then temporarily ghten the bolts so that the media holder adjuster does not fall o.
Tighten
temporarily
Bolts (short): 2