Roland TrueVIS VG2-540 - Page 38

36
2.Installation
1. Assembly and Ink Filling
G
Aach the adjustment bolt
1
.
H
Tighten the adjustment bolt unl the boom of the right arm and the boom of the
media holder adjuster are aligned
2
.
Tighten fully
Adjustment bolt: 1
Adjustment bolt
Align the boom of
the media holder
adjuster with the
boom of the arm.
Arm
Media holder
adjuster
MEMO
At the end of the installaon work, a suitably qualied worker will adjust the media adjuster holder.
Leave this work to the suitably qualied worker.
2.
Aach the media holders.
A
Place the shas on the arms.
First insert the shas into the holes on the right side as seen from the rear of the machine, and
then place the shas into the holes on the le side.