Roland TrueVIS VG2-540 - Step.3:.Make.the.port.settings.for.the.software.rip; Step 3: Make the Port Settings for the Software RIP

60
2.Installation
3. Network Settings
E
Repeat steps
C
and
D
to set [GATEWAY ADDR.] to "255.255.255.255."
For the value to enter for your gateway address, consult your network administrator. Here,
"255.255.255.255" is entered by way of example.
GATEWAY ADDR.
255.255.255.255
F
When you have nished making the seng, press [ENTER].
G
Press [MENU] to go back to the original screen.
Step 3: Make the Port Settings for the Software RIP
The sengs for the soware RIP will be made here. For sengs informaon, refer to the documen-
taon for the soware RIP.
Conrming that a network connection has been established
Refer to the documentaon for the soware RIP you are using.