Roland TrueVIS VG2-540 - Page 61

59
3. Network Settings
2.Installation
C
Press [ ] or [ ] to select the address number.
D
Press [ ].
E
Repeat steps
C
and
D
to set [SUBNET MASK] to "255.255.255.000."
Note: For the subnet mask, make the seng the same value as the one used by the computer.
Here, "255.255.255.000" is entered by way of example.
SUBNET MASK
255.255.255.000
F
When you have nished making the seng, press [ENTER].
G
Press [ ] to go back to the screen shown below.
NETWORK
SUBNET MASK
If you are using the computer and the machine on a one-to-one basis, this completes the sengs to
make on the printer.
Press [MENU] to go back to the original screen. Then, proceed to
P. 60 "Step 3: Make the Port Settings for
the Software RIP"
.
If you need to set the gateway address, proceed to the following procedure.
3.
Set the gateway address
A
Press [ ] to display the screen shown below.
NETWORK
GATEWAY ADDR.
B
Press [ ] twice to display the screen shown below.
GATEWAY ADDR.
000.000.000.000
C
Press [ ] or [ ] to select the address number.
D
Press [ ].