Roland TrueVIS VG2-540 - Page 60

58
2.Installation
3. Network Settings
C
Press [ ] once, and then press [ ] several mes to display the screen shown below.
SYSTEM INFO.
NETWORK
D
Press [ ] three mes to display the screen shown below.
IP ADDRESS
000.000.000.000
E
Press [ ] or [ ] to select the address number.
F
Press [ ].
G
Repeat steps
E
and
F
to set [IP ADDRESS] (192.168.000.XXX).
Here, "XXX" can be any number from 001 to 254. However, be sure to specify a number that is
dierent from the seng you made in Step 1 and from the numbers used for other computers
and devices.
For the part corresponding to "192.168.000," apply the same value as the seng of your com-
puter.
Here, "192.168.000.003" is entered by way of example.
IP ADDRESS
192.168.000.003
H
When you have nished making the seng, press [ENTER].
I
Press [ ] to go back to the screen shown below.
NETWORK
IP ADDRESS
2.
Set the subnet mask
A
Press [ ] to display the screen shown below.
NETWORK
SUBNET MASK
B
Press [ ] twice to display the screen shown below.
SUBNET MASK
000.000.000.000