Roland TrueVIS VG2-540 - Page 66

64
3.Appendix
2.
VG2-640 VG2-540
Environment
During operaon
(*10)
Temperature: 20 to 32°C (68 to 90°F), humidity: 35 to 80%RH (no condensaon)
Not operang Temperature: 5 to 40°C (41 to 104°F), Humidity: 20 to 80%RH (no condensaon)
Included items
Dedicated stands, power cord, media holders, replacement blade for separang
knife, manuals, etc.
*1 The media holders of this machine are designed to be used exclusively with media that has a paper tube (core)
with an inner diameter of 3 inches. To use 2-inch media, the oponal media anges are required.
*2 The length of prinng or cung is subject to the limitaons of the program.
*3 • 500 gf is the maximum instantaneous blade force.
• The blade force must be adjusted according to details such as the media thickness.
*4 • Media type: Media specied by Roland DG Corporaon
• Temperature: 25°C (77°F), humidity: 50%RH
• Roll media must be loaded correctly.
• Applicable when all pinch rollers that can be used with the media width are used.
• Side margins: 25 mm (1.0 in.) or more for both the le and right margins
• Excluding expansion/contracon of the media
• Not assured when the print heater or dryer is used.
• Assumes all correcon and adjustment funcons of the machine have been used properly.
*5 • Print travel: 1 m (39.4 in.)
*6 • [PREFEED] menu item must be set to "ENABLE."
Range for assured repeon accuracy
• For media with a width exceeding 610 mm (24.0 in.): Length: 4,000 mm (157.5 in.)
• For media with a width of 610 mm (24.0 in.) or less: Length: 8,000 mm (315.0 in.)
*7 • Provided that the media feed length is 3,000 mm (118.1 in.) or less
• Excludes the eects of slanted movement and of expansion and contracon of the media
*8 • Data size:
64-inch model: 1,000 mm (39.4 in.) in the media-feed direcon, 1,600 mm (63.0 in.) in the carriage-move-
ment direcon
54-inch model: 1,000 mm (39.4 in.) in the media-feed direcon, 1,346 mm (53.0 in.) in the carriage-move-
ment direcon
• No laminaon
• Automac detecon of crop marks at 4 points when media is reloaded
• During cung, [PREFEED] menu item must be set to "ENABLE."
• Excluding possible shi caused by expansion/contracon of the media and/or by reloading the media.
*9 • Warm-up is required aer power up. This may require 5 to 20 minutes, depending on the operang envi-
ronment.
• Depending on the ambient temperature and media width, the preset temperature may fail to be reached.
*10 • Operang environment
Use in an operang environ-
ment within this range.