Rolls- Ro yce Silver Shadow
B
Bentley
T
Series
Workshop
Manual
Headlamp bulb-To renew
1.
Remove the fairing securing screw, raise the
lower edge of the fairing and unhook it from the
two upper retainers; remove the seal
(see
Fig.
M48).
2.
Press the lamp unit against the tension of tlfe
adjusting screw spring and turn anti-clockwise until
the heads of the screws can pass through the
enlarged ends of the slots in the mounting; remove
the lamp unit.
3.
Detach the terminal socket from the bulb, open
the retaining spring clip and remove the bulb from
the reflector.
When fitting a new bulb, ensure that the groove
and tang of the reflector and bulb assembly
respectively are aligned correctly.
Sealed beam unit-To renew
1.
Remove the fairing securing screw, raise the
lower edge of the fairing and unhook
it
from the
two upper retainers; remove the seal
(see
Fig.
M49).
2.
Unscrew but do not remove the three bezel
retaining screws.
3.
Press the lamp unit against the tension of the
adjusting screw spring and turn anti-clockwise until
the heads of the screws can pass through the en-
larged ends of the slots in the bezel; remove the
lamp unit. Before removing the bezel, hold the lamp
with one hand to prevent it falling out of the
back-
shell.
4.
For reference purposes, the outer lamp units
have twin filaments, the inner lamp units have a
single filament. (For correct lamp units refer to
Section
M19.)
Alignment and setting
When the headlamp units have been disturbed the
alignment of the
headlamp beams should be checked
and reset if necessary.
In order to obtain optimum results,
lt is recomm-
ended
that
the l.ucas Beam Tester blk
111
be used.
Chapter
M
Section
M7
EXTERIOR LIGHTING
FIG.
M48
HEADLAMP SECURING SCREW
1
Securing screw
FIG. M49 ACCESS TO SEALED BEAM UNITS
1
Location pegs
2
Securing screw
3
Vertical beam adjust~ng screw
4
Horizontal beam adjusting screw
5
Lamp socket
To Next Page
Loading...
