ROMET 4E Electric Vehicle Instruction Manual
7
III. Operation Procedures for New Car
1. Notes before using the new car
For a new car, large friction force occurs among running components as car traveling. As running-in of the
components, the friction force will gradually reduce. The following notes are proposed for traveling under 3000km
and with the use of these notes, better operational capacity and economy will be gained after the car running-in.
(1) The traveling speed shall not exceed 40km/h.
(2) It is prohibited to driving the car with over-speed and overload.
(3) The transmission oil must be replaced after traveling 2,000 km.
(4) Emergency braking shall be avoided especially during the first 300Km traveling except for emergency
conditions.
2. Actuation switch: there are three positions for the key in the hole:
Lock (locking position)
The key can be extracted from or inserted into the lock cylinder, and if the key cannot rotate in the cylinder, please
try to slowly revolve from left to right.
When the car is traveling, the key cannot be rotated to the “LOCK” position, or the steering wheel will be locked
and accidents may be resulted from this condition.
Three rotation positions of the key
ACC (accessory position)
When the ignition switch is at "ACC" position, only the assistant power supply for radio etc will be controlled. At
that time, even the motor is closed; the user can enjoy the radio.
ON (starting position)
When the key is at this position, the turn control, radio and motor are all switched on, and the users can enjoy radio
and open the hazard signal switch.
The features not controlled by the key, such as headlight, horn, interior lights and width indicator can be directly used without key. Inspect whether the
To Next Page
Loading...