Front and rear door glass
1. Front door glass
The front door glass can be lifted manually. Turn the lifter handle in
clockwise and the glass will rise; or vice versa.
2. Rear door glass
The rear door glass is only of open/close type which cannot be lifted and
only the ventilation seam can be opened.
3. Dead lock
The inside of the four doors are equipped with manual dead locks
(cylindrical lift button). Press down the button when the door is closed and
the door will be dead locked and the door will be opened by lifting up the
button.
(4) Roof window
1. You must press down the button 1 on the left and right at the same time to
make the button get away from the locating slot before doing other corresponding
operations. Don’t force it!
2. You must clean up the dust on the roof window glass and the seal strip when closing
the window after long-time opening to prevent water leakage.
4. Roof window
The roof window can be kept in three states: fully-closed, forward-opened, and backward-opened.
Fully-closed: make sure that the front and rear fastener close properly. Don’t buckle up falsely, without looseness, or it will damage the window.
Forward-opened: pull back and up the front buckle. It is in a strong ventilation state which is only for fast refreshment of inside air.
Backward-opened: buckle up the front buckles, then open and lock up the rear buckle. It is in a weak ventilation state for slow refreshment of inside air.
The front and rear buckles shall not be opened at the same time or the roof window will be damaged. Don’t open the roof window immediately after the rain. You can
open the window five minutes later when the water between the glass pane and the frame has disappeared.
Dead lock