Romet 4E - Replacement of the Tail Lamp Bulb; Headlamp Bulb Replacement Steps; Replacement of Bulbs

ROMET 4E Electric Vehicle Instruction Manual
31
5. Replacement of bulbs
(1) Headlamp bulb replacement steps:
a. Open the front chamber cover
b. Loose the compressed spring of the lamp bulb covering cap and take off the cap
c. Loose the fixed snap ring on the lamp
d. Pull out of the bulb directly from the lamp door and replace with the same-type
bulb
e. Tighten the bulb and fix the snap ring, then install the sealed cap of the bulb
f. Pull the front fog lamp directly and replace it. The fog lamp is at the bottom part of
the lamp
(2) Replacement of the tail lamp bulb:
a. Open the back door and remove the corresponding interior trim inside the tail lamp
carefully
b. Remove the tail shield with plum screw driver
6. Basic hand tools include the following items:
1. Dual-duty screwdriver
2. Lifting jack (0.75t)
3. Jack handle
4. 13-15 wrench
5. 8-10 wrench
6. Wheel wrench
7. Warning triangle
8. Ignition wrench
9. Trailer hook