Romet 4E - Self-Maintenance

ROMET 4E Electric Vehicle Instruction Manual
42
and use a vacuum dust collector or a brush instead.
It is not allowed to contact the electronic components with water or other liquids.
5、Self-maintenance
Daily and periodic maintenance is a must to maintain good mechanical properties of the car, the emissions performance and engine performance. The user should
carry out the provisions of the specialized maintenance and general maintenance. As the owner, you are the only one who can guarantee the normal maintenance of
your car. You are one of the most critical maintenance aspects.
General maintenance including those items should be checked before normal daily driving，if you want to guarantee your vehicle for continuous normal operation,
this is a basic requirement. Daily use of the vehicle, general maintenance should be conducted regularly, if you notice any abnormal sound, vibration or odor, check
the reasons or rapidly call in the special service station to check. In addition, if you think your vehicle needs repair, please notify Romet motors special service station
Unless there are special provisions, the maintenance of items listed as follows should be timely carried out.
(1)Tire
Use pressure gauge to check tire pressure regularly in the maintenance station. Adjust to the required pressure when necessary.
(2)Wheel nuts
When check the tires, make sure that no wheel nuts is loose. In the initial 1000KM’s driving, regularly check the wheel nuts and tighten if necessary.
(3)Wheels adjusting and balancing
When traveling on a straight and flat road, if the vehicle always deviates to one side, or you are aware of the uneven or unusual wear of tires, it would be
necessary to locate the wheel. When traveling at normal speed, if the steering wheel or seat vibrates, it is necessary to execute the wheel balancing.
(4)Windshield wiper blade
As it is not working properly, check for cracks or wear.
(5)Doors and front hatches
Check if the operations of all doors, front hatches, trunk lid and rear doors are normal, and ensure that all locks are solid. When necessary, lubricate hooks
and hinges. When the first hook is released, make sure the second hook is keeping the engine cover from being loosened. Driving in areas with road salt or other
corrosive materials, frequently check the status of lubrication.