EasyManua.ls Logo

Romet 4E - Operation Procedures of the Electric Vehicle; Parking Brake

Romet 4E
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ROMET 4E Electric Vehicle Instruction Manual
9
it is neutral position. At this time, even slowly
engaging the accelerator, this car cannot travel.
position, and the car will travel after engaging the
accelerator under proper conditions.
And this gear can realize reversing the car (the
reversing red indicator will light up).
Operation procedures of the Electric Vehicle:
For the Electric Vehicles with low-gear transmission, the start-up procedures are as follows: 1. rotate the key to the start-up position; 2.
push the control lever to the forward position; and 3. slowly engage the accelerator pedal. Then you can drive the car.
For the Electric Vehicles with high-low gear transmission, the start-up procedures are as follows: 1. rotate the key to the start-up position;
2. press the forward button of the power switch; 3. push the control lever to the low-gear position; and 4. slowly engage the accelerator
pedal. Then you can drive the car.
No shifting during engaging the accelerator pedal! Slowly engaging the accelerator pedal during start-up can extend the traveling mileage!
If the front wheel can not rotate during acceleration, the user shall not drive the car, while the possible reason is that the wheel has been immersed in the
deep sandpit or muddy ground, or it may be blocked by something hard. At this time, if the car is forced to travel, the differential may be damaged. Likewise,
when the car is traveling uphill, the braking shall not only depend on braking pedal to prevent reversing, or the transmission case may be damaged. At that time,
the car shall be stopped on the slope with parking brake!
4. Parking brake
For parking braking, lift the manual braking handle (1) with your right hand to brake the car. The user shall first
slightly pull the handle up and use the thumb to press the locking button (2) on the handle top in order to release
the braking handle. Put down the handle (3) and the parking will be released.
If the parking brake is not fully engaged, it is very dangerous to leave the car behind, and your car may
voluntarily move due to environmental factors. If the engine is still running, then the car may suddenly
travel resulting in personal injuries. Thus, you shall ensure your car cannot move and inspect the parking
brake is fully engaged.

Table of Contents