Romet 4E - Hauling Speed; Tractors Hauling; Incorrect Way of Hauling

ROMET 4E Electric Vehicle Instruction Manual
36
b. Do not add extra vehicles to haul one vehicle. The traction of hauling vehicle include the traction of the trailed vehicle, the total traction is larger than the weight of
the trailed vehicle, the pot hole or wallow will put drag on the hauling, therefore, the traction load increased. The traction load must be minimized.
c. During hauling the vehicle by towing hook, keep the angle of traction less then 15°. If the angle is too large, it may damage the vehicle, even cause the vehicle
turns 180°.
d. During pulling the vehicle out of sandpile, snow or mud, the mooring rope must be pulled out straightly in front of the vehicle, but the mooring rope and the hook
can not be formed a side angle.
(5) Hauling speed
If in the process of hauling a vehicle which is sunk into a pit or wallow, keep a safe distance from the hauling cable or drag rod. Once the hauling cable is broken,
great danger will happen.
When haul separately excited motor assembled vehicle, the hauling speed must be less than 30 kilometers per hour.
(6) Tractors hauling
（1）incorrect way of hauling
The vehicle can not be hauled as the graphical way of using sling (type A), using sling will damage the front bumper and the front structure.
(2) correct way of hauling
a. If the vehicle equipped with automatic clutch must be towed over 50 kilometers, then during the transporting, all tires must be off the ground (type B or C), or the
back wheels off the ground (type E), showed in the picture.
b. If the engine or the differential is broken, then during the transporting, all tires must be off the ground (type B or C), showed in the picture.