ROMET 4E Electric Vehicle Instruction Manual
32
7. Replacement of windshield wiper blade
a. Cut off the ignition switch when the wiper is in the most outside position where will be easier for the removal or replacement of the blade.
b. Pull away the wiper from windshield
c. Push up the release clip at the joint of the blade and the wiper arm and then pull down the blade component towards the glass. You can remove the blade
component from the wiper arm.
d. Push the new blade close to the wiper arm until a sound of “clatter” is heard, which means the release clip is positioned.
8. Tire without gas
1) If you need to stop the car on the road in this case, try to pull the car away to the right side (or left side) of the road and avoid stop on the pavement.
2) Tighten the hand brake and put the warning triangle in a suitable position at the back of the car (day or night).
Note: Warning triangle is kept together with the basic tools.
3) In case of tire burst
In case of replacing the tires due to the burst, first you must follow the safety precautions: open the hazard warning flasher. Don’t stop on the main roads and make
sure that the car is parked on a flat road which won’t damage the car. Pull the parking brake and place the manual transmission to a reverse position.
9. Vehicle identification number (VIN)
The identification number is in the position as shown in the picture.
10. Name plate
To Next Page
Loading...