ROMET 4E Electric Vehicle Instruction Manual
38
If the headlamps or other electrical equipment parts do not work, it is necessary to check the fuse. If the fuse has been burnt out, then replacing is required, there are
two spare fuse in the fuse boxer. Shut down the ignition switch and the parts that do not work, unplug the faulty fuse to check.
If the fuse has been burst out, the new fuse needs to be installed at original location. It can only be installed the fuse which has the same amperage as specified on
the box cover of the original fuse. If there is no equivalent fuse, adopt the fuse with lower amperage, but need to replace a proper fuse as soon as possible, then put
the original fuse back the original clip. It had better buy one set of spare fuse for emergency. If the brand new fuse is burst out immediately, then there is a potential
problem in the electric system. You need to go to Romet motors special service station to conduct maintenance.
Do not use fuse higher than amperes, or any other substance to replace the fuse, otherwise serious damage will result and have a potential risk of breaking out of
fire.
To Next Page
Loading...