4-10
Rosco Maximizer 2B Asphalt Distributor
Speciî›™cations
Torque Specs
Metric Fasteners
The following Table lists torque values
for standard hardware and are intended as a guide
for average application involving typical stresses
and machined surfaces. Values are based on
physical limitations of clean, plated and lubricated
hardware. In all cases, when an individual torque
value is speciî›™ed, it should be followed instead of
values given in this table.
Replace original equipment with
hardware of equal grade.
Inch Fasteners
The following Table lists torque values
for standard hardware and are intended as a guide
for average application involving typical stresses
and machined surfaces. Values are based on
physical limitations of clean, plated and lubricated
hardware. In all cases, when an individual torque
value is speciî›™ed, it should be followed instead of
values given in this table.
Table 4-6. Torque Speciî›™cations For Metric Fasteners
CLASS 8.8 [GRADE 5 EQUIVALENT] CLASS 10.9 [GRADE 8 EQUIVALENT]
NOMINAL SIZE
& PITCH
TORQUE FT. LBS. TORQUE N•m TORQUE FT. LBS. TORQUE N•m
Dry Lubed Dry Lubed Dry Lubed Dry Lubed
M4 x 0.7 2.27 1.70 3.07 2.30 2.27 2.31 4.17 3.13
M5 x 0.8 4.58 3.43 6.20 4.65 6.22 4.67 8.43 6.33
M6 x 1 7.75 5.83 10.5 7.90 10.60 7.97 14.3 10.8
M8 x 1.25 18.89 14.17 25.6 19.2 18.95 19.26 34.8 26.1
M10 x 1.25 39.11 29.52 53.0 40.1 53.87 40.59 73.0 55.0
M12 x 1.75 64.94 48.71 88.0 66.0 88.56 66.42 120.0 90.0
M14 x 2 103.32 77.49 140.0 105.0 140.22 107.01 190.0 145.0
M16 x 2 162.36 121.77 220.0 165.0 221.40 166.05 300.0 225.0
M20 x 2.5 317.34 236.16 430.0 320.0 428.04 321.03 580.0 435.0
M24 x 3 516.12 409.59 740.0 555.0 754.38 557.19 1010.0 755.0
M27 x 3 797.04 597.78 1080.0 810.0 1084.86 811.80 1470.0 1100.0
M30 x 3.5 1084.86 811.80 1470.0 1100.0 1476.00 1107.00 2000.0 1500.0
Replace original equipment with
hardware of equal grade.
Return to
Last Viewed
Return to
Thumb Index
To Next Page
Loading...
Need help?
General