Rosco Maximizer 2B - Handspray; Unload Mode

6
Rosco Maximizer 2B Asphalt Distributor 6-31
Operation
Handspray / Unload Mode
The operator may choose to use the HANDSPRAY/
UNLOAD mode (Figure 6-21) which allows the use of
higher pressure. However, if the level of material in
the tank is above the return line, this mode may allow
material to return to the spraybar.
This mode signicantly increases the
pump pressure since the 2-Way and 3-Way valves
are closed. Be sure to maintain a rm grip on the
handspray wand.
NOTE: All material that is being pumped will be sprayed,
so running the pump at a slower speed than
in Tank Circulate Mode will still deliver higher
pressure.
Return to
Last Viewed
Return to
Thumb Index